How to organize appliance cords on the kitchen counter
Loose cords are most of what makes a counter look cluttered. Wrap each appliance's own cord on the appliance, clip charging cables to the counter edge, and the counter stays clear between uses.
Step by step
- Pick a cool spot on each appliance. Choose the side or back of the appliance, away from the air outlet and anything that gets hot. On an air fryer, hot air usually comes out of the back, so check where yours vents before you stick anything.
- Clean the spot. Wipe it with water to remove grease and dust, then let it dry completely.
- Press and wait. Press the winder on firmly for 30 seconds, then wait a few hours before you wrap the cord, so the adhesive can set.
- Wrap the cord and clip the plug. Wrap the cord around the winder when the appliance is off, and push the plug into the clip.
- Clip chargers and thin cables. Stick magnetic cable clips on the counter edge, the wall or under a cabinet for phone chargers and thin cords up to about 7 mm thick.
- Unwind before use. Unwrap the cord fully before switching an appliance on — a wrapped cord can't cool down.
What goes where
| Cable | Use | Where |
|---|---|---|
| Air fryer, kettle, toaster, mixer cord | Stick-on cord winder with plug clip | Side or back of the appliance, away from vents and hot surfaces |
| Phone and tablet chargers | Magnetic cable clip | Counter edge or wall by the socket |
| Thin cords up to about 7 mm | Magnetic cable clip | Under the cabinet or along the backsplash |
| Thick or heavy cords | Cord winder, not a clip | On the appliance itself |
Don't
- Don't stick winders next to an air outlet, on the lid, or on any surface that gets hot.
- Don't run an appliance with its cord still wrapped.
- Don't stick on a greasy or wet surface — the adhesive won't hold.
Questions
Will the adhesive hold on an air fryer?
Yes, on a clean, dry, cool part of the housing. Wipe the spot, press for 30 seconds and give it a few hours before loading.
How do I take a winder off?
Peel it slowly from one corner. Going slowly is the best way to avoid leaving residue.
